Setting parameters for inverse simulation

On the Inverse tab you select the solver for the inverse simulation and specify the parameters for the solving process. Before computing inverse simulation you need to define controlled power heaters, see Heaters, and control points, see Control Points for Inverse Simulation.

A detailed description of parameters is given in Inverse section.

  1. Select Computation > Numerical parameter > Inverse tab.

    The Inverse dialog opens:

    Inverse tab in Numerical parameters dialog 

    Figure 17. Inverse tab in Numerical parameters dialog

  2. The default values were gained from experience and produce satisfactory results. Change the defaults only if inevitable.

    If necessary, change the inverse solver, the preconditioner, the parameters, the controller and the conditions for updating the sensitivity matrix.

  3. Click on Apply and Close.

    or

    Click on OK to apply the changes and to close the dialog.

Related Procedures

Running an Inverse Simulation

Related Dialogs

Inverse