Opening the Boundaries dialog

  1. The next dialog offers three types of temperature boundaries:

    Select Settings > Boundaries.

    The Boundaries dialog opens:

    Boundaries dialog for temperature 

    Figure 7. Boundaries dialog for temperature

  2. In the LGF_prototype.crys file boundaries were set at all border lines. You can display them as follows:

    Click on Show all.

    Type and value of all boundaries set are displayed.

    All boundaries displayed 

    Figure 8. All boundaries displayed

    The partial view of the furnace illustrates the kind of information you get:

    Partial view of boundaries 

    Figure 9. Partial view of boundaries

  3. Because you did not make any changes, only the Close button is active.

    Click on Close to close the dialog.

Related Procedures

Boundary Conditions

Related Dialogs

Boundaries