Specifying growth rate in the Process parameters dialog

In this dialog some values relevant for particular settings are set, such as specifying the growth rate for pseudo-stationary computation or setting process parameters for traveling or rotating magnetic fields. Specifying the growth rate is necessary for pseudo-stationary simulations.

  1. Select Computation > Process parameters.

    The Process parameters dialog opens:

    Process parameters dialog: General tab 

    Figure 11. Process parameters dialog: General tab

  2. The growth rate has to be specified in m/s.

    Replace the 0 by 0.001 for a growth rate of 1 mm per second.

  3. Click on Apply and Close.

Related Procedures

Specifying growth rate in the Process parameters dialog General process parameters

Related Dialogs

General process parameters