Labels

This dialog is opened via Settings Menu.

The labels dialog enables you to assign labels to regions and lines. For instance, before joining a cartridge with a furnace insert in a SQF configuration the contact region and the contact line need to be labeled.

Labels dialog 

Figure 22. Labels dialog

Item

Description

Regions

Sets a label to all selected regions:

  • Label

    Input field used to specify the label.

  • Keywords

    List of predefined labels:

    • WallHeatFluxRef: names a region to be considered as reference region in heat flux monitoring across a line from this region.

    • LMR: names a region which belong to the cartridge's LMR.

Lines

Sets a label to all selected lines:

  • Label

    Input field used to specify the label.

  • Keywords

    List of predefined labels:

    • Sliding: names a sliding line of a moving region in order to not distort their neighbors during moving operation.

      Note

      You should label the line at the boundary of the moving region as sliding if the positions of the line end points should be unchanged during the moving.
    • Contact: names the contact line between cartridge and furnace insert requested by joining process.

    • Nucleation: names the line on which the columnar growth starts. Used only in the multi-scale model.

Related Procedures

Moving Regions

Labels and Joiner